Ram-mount RAM-VB-172-SW1 User Manual download pdf

Installs in minutes with no drilling required.

Lifetime warranty!

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Vehicle base for the

SPECIFICATIONS

Placement

Passenger side, in front, where seat frame meets

floor board.

Drilling Required

None - uses existing seat bolts

Seat Configuration

Bucket

Pole or Pedestal

Ordered Separately

Weight

6.1 lbs

Construction/Finish

Steel/Black Powdercoat

Dimensions

A = 18.23", B = 7", C = 1.95",

Hole Center = 16.31"

Features

Complete Vehicle Mount

RAM-VB-172-SW1

RAM No-Drill TM Seat Bases

National Products, Inc.

Item Number

RAM-VB-172 & RAM-VB-172-SW1

FORD EDGE (2007-2013)

FORD FUSION (2013)

Vehicle Base

RAM-VB-172

National Products, Inc.

Website: www.ram-mount.com

Email: [email protected]

8410 Dallas Ave S

Seattle, WA 98108

Phone: (206) 763-8361

Fax: (206) 763-9615

National Products, Inc.

Website: www.ram-mount.com

Email: [email protected]

8410 Dallas Ave S

Seattle, WA 98108

Phone: (206) 763-8361

Fax: (206) 763-9615

Vehicle base for the

INSTALLATION INSTRUCTIONS

Depending on your make and model, there may be pieces of plastic trim that cover the lower front of the seat frame

legs. This will need to be removed and stored. If you wish to reinstall this piece of trim, you will have to modify it to fit

over the stamped metal base.

1. Move the passenger side seat to its rearmost position. Using socket wrench, loosen and remove the two

bolts holding the seat frame legs to the floor board.

2. Place the No-Drill™ base over the seat frame legs with the pedestal platform near the center of the vehicle.

Note that for the Ford Fusion, the base will install under the seat frame legs, not over them.

3. Re-install the two seat frame bolts. Start the thread by hand and then fully tighten with the 18MM wrench.

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

RAM No-Drill TM Seat Bases

National Products, Inc.

Item Number

RAM-VB-172 & RAM-VB-172-SW1

FORD EDGE (2007-2013)

FORD FUSION (2013)

The photo below depicts the install into a Ford Fusion. The arrows show areas where the fit is tight. This base does

touch the carpeting of the center hump. It will also touch and flex slightly the plastic seat leg covers. This does not

affect the functionality or appearance of the seat leg covers.

1 2

RAM No-Drill TM Seat Bases 1

Summary of Contents

Page 1 - RAM No-Drill TM Seat Bases

Installs in minutes with no drilling required. Lifetime warranty!This document, including images, may not be reproduced partly or fully without the e

Page 2

Installs in minutes with no drilling required. Lifetime warranty!This document, including images, may not be reproduced partly or fully without the e

Comments to this Manuals

No comments

Ram-mount RAM-VB-172-SW1 User Manual

Browse online or download User Manual for Accessories communication Ram-mount RAM-VB-172-SW1. RAM Mount RAM-VB-172-SW1 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Accessories communication Ram-mount RAM-VB-172-SW1